0000200 REV C E - m a i l: t e c h f r a n k l i n f u e l i n g. The PMP product described here is manufactured or remanufactured and sold by PMP and is not the product of any other identified manufacturer. PMP does not claim any right to or affiliation with such owners. 677.9656 Local Enews Signup *All product or company's names, trade names, trademarks, parts numbers and part descriptions may be the trademarks of their respective owners, and are used for reference or identification purposes only. Tamil Islamic Mp3 Audio Songs Free Download on this page. Sis To Sisx Jar Converter Full Download.Ĭontact PMP Corporation 25 Security Drive Avon, CT 06001 USA 800.243.6628 Toll Free 888.674.0196 Fax 860. Manufacturer: EBW Warranty Period: Details Call Us Email Us. For full details, please refer to our expanded ' page.Parts EBW AUTO-STIK I AUTO-STIK I. Franklin Fueling Systems Evaluator: Ken Wilcox Associates 3760 Marsh Road Tel: (816) 443-2494 Madison, WI 53718 Dates of Evaluation: 05/14/98, 08/21/02 Tel: (800) 225-9787 E-mail: URL: Appearance on this list is not to be construed as an endorsement by any regulatory agency nor is it any guarantee of the performance of the method or equipment.Įquipment should be installed and operated in accordance with all applicable laws and regulations. EPA leak detection regulations require testing of the portion of the tank system which routinely contains product. Consistent testing at low levels could allow a leak to remain undetected. Tests only the portion of the tank containing product.Īs product level is lowered, the leak rate in a leaking tank decreases (due to lower head pressure). This equipment was not evaluated using manifolded tanks. Therefore, this certification is only applicable when there is a probe used in each tank and the siphon is broken during testing. Comments Not evaluated using manifolded tank systems. Calibration Thermistors and probe must be checked and, if necessary, calibrated in accordance with manufacturer's instructions. Minimum detectable water level change is 0.011 inch. Minimum detectable water level in the tank is 0.208 inches. Water Sensor Must be used to detect water ingress. At least one thermistor must be submerged in product during testing.įree Download Mp3 311 Love Song 4shared Free here. Temperature Probe contains 5 thermistors to monitor product temperature. There must be no dispensing or delivery during the test. Leak rate is calculated from data determined to be valid by statistical analysis. Test data is acquired and recorded by system's computer. Average data collection time during the evaluation was 6 hours, 51 minutes. Test Period The length of the test is determined automatically based on quality of test data. There must be no delivery during waiting time. Minimum of 2 hours between dispensing and testing. Waiting Time Minimum of 4 hours 9 minute between delivery and testing. For other diameters, see evaluation report.

Minimum product level required based on tank diameter as follows: 48' dia/min 12' 64' dia/min 14' 72'dia/min 15' 96' dia/min 17.5' 126'dia/min 21.5'. Applicability Gasoline, diesel, aviation fuel, fuel oil #4. 89 Instruction Manuals and User.Ī tank system should not be declared tight if the test result indicates a loss or gain that equals or exceeds this threshold. Integrated Electronic Services offers the finest in new parts and equipment. EPA does not endorse any specific release detection devices. These sources alone are responsible for the veracity of the information presented here. PLEASE NOTE: The information in this booklet comes from third-party evaluations and from release detection equipment vendors.

Diagram: A Tank Sentinel (Except TS-2001), AutoStik Jr, BulkStik, AutoStik II (1-4ch). Main System Board Installation for Tank Sentinel, AutoStik, BulkStik ATGs. Prepared by Ken Wilcox Associates for the. Systems, and Mechanical Line Leak Detectors. Automatic Tank Gauging Systems, Electronic Line Leak Detection. Leak Threshold 0.1 gph.įield Evaluation Study of. Leak rate of 0.2 gph with PD = 95.7% and PFA = 4.3%. Certification Applies only to AutoStik II and AutoStik Jr. (INCON, EBW LL2 Magnetostrictive Probe) AUTOMATIC TANK GAUGING METHOD As of April 1, 2009, Franklin Fueling systems no longer manufactures this method. E Issue Date: JRevision Date: ApFranklin Fueling Systems (originally listed as EBW, Inc.) AutoStik II, AutoStik Jr.

Ebw auto stik jr manual